PrintLogo

Z-80 Homebrew Computer - More Pictures




There are 12 parts to this article:
1 - 2 - 3 - 4 < 5 - 6 - 7 - 8 - 9 - 10 - 11 - 12

Here is a look at the back of the case. The three on the left are 309k 5v linear regulators. The three on the right are 7812 12v :



Here is a look at the back of the I/O board. This picture was taken before many of the solder joints failed. I had to rip off most of the heat glue over time to repair the bad joints.



Here is a look at the CPU board. The two 74154s are on the left. The Z-80 is on the right, and a 1 Mhz crystal oscillator is in the top right corner.:



Front panel lit up:



Another closeup of the lamps. Did I mention that I really like these 330 incandescent lamps?



The ritual of fixing cold solder joints:



This homebrew has been in five different houses, so the pictures vary a bit. It has take awhile to get this project wrapped up and documented.



This article comes from Coprolite:
http://coprolite.com/

The URL for this story is:
http://coprolite.com/art4.html

Copyright 1997-2006 Coprolite.com. Read our Terms of Use.